sku: DEV-10570

The Danger Shield mounts on top of your Arduino r Arduino Pro and equips it with a variety of fun and useful inputs and outputs. The Danger Shield has so much potential; we can’t wait to see what you’re able to do with it! The shield’s features include:

Three linear slide potentiometers connected to the Arduino’s analog pins 0 through 2.
Red and yellow LEDs connected to digital pins 5 and 6 – PWM pins – so you can easily vary their brightness.
Three momentary push buttons connected up to the Arduino’s digital pins 10 through 12. Those lines will go low when the buttons are pressed.
A photocell and a temperature sensor, both with analog outputs, are connected to the analog pins 3 and 4, respectively.
An 8-bit shift register set up to control a blue 7-segment LED.
Two buzzers – one is used, as you’d expect, as a speaker, the other is connected to analog pin 5 and can be used as a knock sensor.
Capacitive Touch pad – Using the CapSense library to sense touch.

This product comes as a kit of parts, which you’ll have to solder into the included PCB. All parts are through-hole so it should go together relatively easily; but always check your component orientation before soldering!

Kit Includes