Simpson H3 Zinc Galvanized Hurricane Tie (Left & Right)

• Model No.H3
• Ga.18
• W (in.)1 9/16
• H (in.)4 5/8
• Coating/Material. Zinc Galvanized, G90

This product is sold in pairs and you will be shipped 1 LH and 1 RH piece per each pair ordered.

The H3 single-sided hurricane tie is designed to resist moderate loads at the rafter/truss-to-top-plate connection. As part of a continuous load path, the H3 resists both lateral and uplift loads. H3 ties are available in left- and right-hand models and can be installed in pairs.

Installation:

• Fasteners Required. Each Tie (8) Nails 0.131 x 2-1/2″ or (8) #9 x 1 1/2″ Strong-Drive SD Connector screws
• Use hot-dip galvanized (HDG) nails with ZMAX and HDG connector products. Use Type 316 stainless-steel nails with our stainless-steel connector products.
• Hurricane ties do not replace solid blocking.
• When installing ties on plated trusses (on the side opposite the truss plate) do not fasten through the truss plate from behind. This can force the truss plate off of the truss and compromise truss performance.