The LTHJA26 is a lighter-capacity version of the THJA26 and offers the lowest-cost alternative for light hip/jack load applications.

Installation

Fasteners required. Install with 10d and 10d x 1-1/2in. Nails
All members must be fastened together to act as a single unit.
Shall be attached to a double-girder truss to allow for required minimum nail penetration. See load table notes for girder truss requirements.
0.148″ x 1 1/2″ nails must be installed into bottom of hip members through bottom of hanger seat for table loads.

Add a Review

Your email address will not be published. Required fields are marked *