BIQU Panda Cushion XP | Shock-Absorbing Feet | Bambu

BIQU Panda Cushion XP Shock-Absorbing Foot Pads

The BIQU Panda Cushion XP is a set of shock-absorbing replacement feet for Bambu Lab P2S, P1S, P1P, X1C, and X1E printers. It is designed to reduce vibration transfer, limit lateral movement, and give the printer a more stable base during high-speed motion.

BIQU describes the structure as a large bearing ball plus multi-layer damping design, with metal, ABS, and PC construction for support and anti-slip behavior. Each pad is listed at 4.8 x 3.3 cm, keeping the upgrade compact while still giving the printer a broader, more controlled contact point.

For a more complete printer base setup, combine it with BIQU Panda Under Armor PX for underside protection, BIQU Panda Stack for A1 storage organization, or BIQU PANDA-VERSE Storage when building a larger Panda-Verse workstation.

Technical Specifications

Board Layout & Label Guide

• Top contact point supports the printer base after replacing the original foot.
• Large bearing ball helps manage motion while keeping lateral support.
• Multi-layer damping body absorbs vibration transferred from the printer frame.
• Outer shell protects the damping structure from normal handling.
• Anti-slip bottom contact area helps keep the printer planted on the desk.
• Low-profile form keeps the printer height change modest.
• Four-piece layout supports all corners evenly when installed correctly.
• Dust-resistant geometry helps maintain smooth damping behavior over time.

Packing List

• 4 x BIQU Panda Cushion XP shock-absorbing foot pads
• 1 x Product packaging
• Printed instructions or accessories may vary by batch

FAQ

Q: Which printers are supported?

A: BIQU lists Bambu Lab P2S, P1S, P1P, X1C, and X1E compatibility for this Cushion XP listing.

Q: What does the upgrade improve?

A: It helps reduce vibration transfer, resonance, and lateral movement from the printer to the desk.

Q: What is inside the foot design?

A: BIQU describes a large bearing ball plus multi-layer damping structure.

Q: What are the materials?

A: The official product information lists metal, ABS, and PC construction.

Q: How large is each pad?

A: Each pad is listed at 4.8 x 3.3 cm.

Q: Do I need to modify the printer?

A: No permanent modification is normally required. The pads replace the original feet.

Q: Will it solve every vibration issue?

A: No single foot pad can fix loose hardware, poor calibration, or an unstable desk. Check the printer and workbench first.

Q: What should I check after installation?

A: Make sure all four pads are seated evenly and the printer does not rock before starting a print.