Name: Pololu Basic SPDT Relay Carrier with 5VDC Relay (Partial Kit)
SKU: ZB329533112
Availability: InStock

Description
Reviews (0)

ThePololubasic relay carrier modules allow simple control of a single-pole, double-throw (SPDT) switch from low-voltage, low-current control signals.

This item includes the basic carrier PCB along with an Omron G5LE-14-DC5 5V relay, 5.0 mm terminal blocks, and 0.1″ male headers in straight and right-angle versions. Surface-mount components are pre-assembled on the PCB, but the through-hole components are not installed. The included power relay is rated for up to 10 A under most conditions.

We also stock a fully-assembled version.

Warning:This product is not designed to or certified for any particular high-voltage safety standard.Working with voltages above 30V can be extremely dangerousand should only be attempted by qualified individuals with appropriate equipment and protective gear.

The carrier board routes the three relay control pins to 0.1-spaced pins compatible with standard solderless breadboards and female servo cable connectors.

This partial kit version includes 81 straight and right angle 0.1 male header strips that can optionally be broken into 31 pieces and soldered in. The relay switch pins are routed to a set of large pads intended for use with a 3-pin 5mm-pitch terminal block and a set of smaller pads with a 0.2 pitch, making them compatible with 0.1 perfboards.

The partial kit includes a 3-pin terminal block that can be optionally soldered in. The carrier board has four mounting holes that work with #2 or M2 screws.

Advantages over similar products

Compact layout
Two LEDs to indicate coil actuation
Zener diode for fast current decay on relay coil
Specification of electrical routing clearance rules on relay switch nodes

Using the relay module

The switch portion of the relay is accessible on one side of the board while the control pins are routed to the other. The relay coil is powered by supplying the appropriate coil voltage for your specific relay across the VDD and GND pins, and it is activated by a digital high-control signal on the EN pin.

The control signal is fed directly to a BSS138 N-channel MOSFET, which in turn actuates the relay coil when the control voltage exceeds approximately 2.5 V, up to a maximum of 20 V (seeBSS138 datasheetfor details).

The relay switch terminals COM (common), NO (normally open), and NC (normally closed) are routed on the PCB with a minimum clearance of 60mils (1.5mm) from other copper. The copper traces are designed to be at least 45mil (1.1mm) from the board edges, though manufacturing variations in the board edges can make those distances slightly lower.

In most applications, the current and voltage ratings for the module will match the ratings of the relay used. Maximum current, maximum voltage, and life expectancy are interdependent; we, therefore, recommend careful examination of your relays datasheet.